Optimizing PE Protective Film for Environmental Durability and Visual Clarity

PE protective film and the middle of the product to be maintained adhesion is not strong, in the transportation and use of the whole process of the situation of falling, the cause of these problems occurring immediately after the problem is the opposite, the greater the possibility is that the protective film products in the manufacture of polyurethane resin viscosity are insufficient. There is also a probability that the customer in the development of the post mold in the case of the film press does not have enough pressure, or the surface of the profile is not cleaned up neatly, there is dust or spray paint, etc., jeopardize the actual effect of adhesion of sensitizer. If this problem occurs, it is necessary to treat the cause of the problem by removing and replacing the sensitizer to increase the working pressure of the window film or paying attention to the surface of the profile in the process of the window film to carry out a reasonable and adequate cleanup to prevent this kind of problem from occurring.

Protective film in the use of a period after the central performance in the middle of excellent, but the two sides of the wing up, the primary factor, in this case, is the protective film in the whole process of adhesion with the maintenance of the profile, the level of its Lashin is relatively large, in the post after a good, meet the high temperature of the natural environment, the occurrence of excess shrinkage, this problem occurs in the southern region of the user's products, and therefore the PE protective film need to pay attention to the production process! Therefore, PE protective film in the production process needs to pay attention to the natural environment temperature difference on the application of the product to provide harm in the whole process of sticking to avoid a lot of unnecessary surface Lashin.

Protective film products of the open glue problem, this problem in the profile protective film on the reflection of more, when the customer to profile installation project after the end of the construction of the protective film from the surface of the profile to remove the situation, the protective film the central performance of the adhesive is not accompanied by the protective film but is the residue in the profile products, which is the customer does not want to see, due to the inconvenience of this, it must be dedicated staff to scrape off the profile from the strong adhesive, incredibly time-consuming and time-consuming, these occurrences of the protective film, the protective film, the protective film, the protective film, the protective film, the protective film, the protective film, the protective film, and the protective film. Time-consuming, there are a variety of probabilities of these problems occurring; the greater the likelihood is that the protective film products with the working pressure of the adhesive do not meet the requirements but also too dense, resulting in PE protective film products in the peeling, the external support force exceeds the thermal stress, and residual in the profile.

PE protective film adopts an effective three-layer structure; its surface layer is frosted; the use of fingerprints can effectively prevent intrusion; general finger sliding does not leave traces, even if the residue of sweat and other liquid residues, gently wipe the hand can be cleared, a greater extent to ensure that the visual effect of the screen, the material is treated with a unique process that can effectively prevent light reflection, reduce the problem of reflections in the sunlight and the screen.
PE protective film material has a higher transmittance. It is the material of the LCD screen protection film without visual obstacles. It has good mechanical properties and is resistant to oil, dilute acid, alkali, and other solvents. It has good impact strength, which is better than other materials by 3 to 5 times.

PE protective film is weather resistant and can withstand low temperatures of -70 degrees Celsius and high temperatures of up to 150 degrees Celsius to prevent water vapor infiltration. It has a good water vapor barrier function, strong protective performance, environmentally friendly materials, is non-toxic and non-polluting, and is a natural safety material.